Hawksmoor Dirty Water Pump 1100W

Need to remove large volumes of dirty water? This 1100W dirty water pump from Hawksmoor combines power and performance to do the job quickly and efficiently. An impressive flow rate means it’s capable of pumping out up to 308 litres per minute – that’s more than 18,000 litres in an hour.
The pump is made from high-quality stainless steel, and the motor is protected by a high-grade mechanical seal which further reduces the need for maintenance. It can be fully submerged and lowered to a water depth of 7m – simply attach a rope to the sturdy handle on top, so you can submerge, lift or secure the unit easily and safely.
Suitable for use in dirty water containing solids or particles of up to 20mm in diameter, the pump is perfect for clearing water from footings and ditches, as well as general duties. Using it with water containing abrasive substances such as sand should be avoided, and it’s not suitable for continuous use either – it’s recommended to rest the pump for 10 minutes after each hour of use, so it’s not suitable for fish ponds or fountains.
For added peace of mind, thermal overload protection will turn off the pump if the motor starts to overheat. It also comes with a float switch, which can turn the pump on or off automatically with changes to the water level – this ensures you’ll use no more electricity than you need to.

• AC 230V, 50Hz
• Maximum pump rate: 308L/min
• Maximum lifting height: 8m
• Maximum submergence depth: 7m
• Maximum grain size: 20mm
• Hose connection: 25mm / 32mm / 40mm
• Lowest pump start-up level: 135mm
• Minimum water level: 33mm
• Maximum water temperature: 35°C
• Float switch turns pump off automatically with changes to water level
• Sturdy handle helps you move the pump more easily
• Thermal cut-out automatically switches pump off if motor overheats
• Automatic air bleed valve releases any air pockets in the pump body
• 10m cable length with BS plug
• IPX8 rating
• This pump is non-returnable once used, for health and safety reasons